accessories

Canopies:	An overhanging or projecting roof structure that is supported and restrained at one end only, with the extreme end usually unsupported.
Framed Openings:	This accessory is used to open portions of a wall that are normally used for access. Used to frame out doors, windows, louvers, and any other openings. Framed opening refers to the framing members and flashing which surround an opening.
Louvers:	Wall mounted accessory for allowing airflow into the building. An opening provided with fixed or movable slanted fins to allow flow of air.
Mansards/Facades:	A decorative trim or panel system projecting from the face of a wall panel.
Parapet walls:	Parapet walls differ from mansards/facades in that parapet walls have no projection. The wall panels below the roof line continue past the eave line to a given elevation.
Partitions-Longitudinal:	Interior or Exterior wall System. Partitions are walls that are inside the building design to section off parts of the interior space of a building. Longitudinal Partition run in the direction parallel to the ridge or sidewall
Partitions-Transverse:	Same as above except a Transverse Partition runs in the direction parallel to the main frames
Purlin Extensions:	An overhanging or projecting roof structure with the extreme end usually unsupported on the endwalls.
Roof Vents:	An accessory, used on the roof, that allows air to pass through.
Skylights:	Translucent panel formed like the roof panel in place of certain roof panel sheets to supply natural light to the building.
Sliding doors:	A single or double leaf door which opens horizontally by means of overhead trolleys.
Valley gutters:	Special gutter used to carry off water from attached buildings or multi-gabled buildings.
Walk doors:	Personnel doors available in a variety of configurations.
Wall lights:	Translucent panel in the same profile as the wall panel that allows natural light into the building.
Windows:	Self-flashing, self-framing horizontal slide or fixed narrow-lite windows.

ACCESSORIES